Snap Edge Corporation

snapedge.jpg (15846 bytes)

INJECTION MOLDED PLASTIC EDGE RESTRAINT
FOR CONCRETE/CLAY PAVERS

UNIQUE ONE PIECE DESIGN ALLOWS FOR
BOTH STRAIGHT AND RADIUS EDGES

Installation Guidlines____________________________________________

Excavate and install gravel base at least 6" past the perimeter of the actual paved area.
Consult your paving stone supplier or soils engineer to determine the proper base depth for the particular installation.
Snap all pieces together at tongue and groove connection to form a strong uniform edge along entire length.
Spike Snap Edge down on top of compacted and graded base. One spike every two feet for walks/patios, one spike every foot for driveways.
Screed sand from the top of Snap Edge using a 2" x 4" notched out ž".
Backfill the entire perimeter with topsoil and then seed or sod as normal. The full depth backfill allows the roots to help anchor the edging in place

1. Snap Edge
2. 8"-10" Spike
3. Soil
4. Turf
5. Sand Jointed Paver
6. Sand Setting Coarse
7. Aggregated Base
8. Compacted Subgrade

TIPS FOR QUICK AND EASY INSTALLATION WITHOUT PRE-PLANNING

sharpincorner.jpg (11653 bytes)

sharpoutcorner.jpg (9792 bytes)

wall.jpg (7861 bytes)

Sharp Inside Corner

Sharp Outside Corner

Proper Wall Installation

For a sharp inside corner remove one or two nail hole bosses and bend to desired shape.

For a sharp outside corner 'snip' support and bend.

'Bend' Snap Edge to form a better seal against walls etc., (gaps allow sand leaks and paver failure.)


Gentle Outside Curve	Gentle Inside Curve	Pieces Snap Together
'Snip' supports and bend.	'Snip' and bend. Overlap supports.	Fasten Snap Edge lengths together by inserting tongue on one piece into slot of adjoining piece.